Faucet aerators are easy to remove. with this step-by-step guide, you’ll be able to do it yourself, easily and effectively.
Remove It by hand
Begin by trying to unscrew the aerator by hand. They’re threaded and often come off without much fuss. For a better grip, ensure the faucet spout is dry.
Bring in the pliers
If hand removal fails, employ pliers. Use rubber-lined ones to prevent scratching or wrap the faucet with masking tape for protection. Unscrew counter-clockwise and switch positions if it’s stubborn. Be gentle to avoid deforming the metal.
Apply gentle heat
If it's still stuck, and you’re working with metal, a hairdryer might do the trick by expanding the metal slightly. Plastic aerators or those with rubber should not be heated to prevent damage.
Grab the oil
For a particularly stubborn aerator, apply a penetrating oil like WD-40. Spray the threads, wait, and then try removing it with pliers. Patience is key here—it might take a few tries.
Male or female aerators
If an aerator has threads on the inside, it’s a female aerator(Same as Hirator aerator). Female aerators are installed on male faucet spouts that have threads on the outside. If the aerator has external threads, it is a male aerator and will be connected to a faucet spout with internal threads(You may need an adapter ).
Standard aerators
Standard aerators come in three sizes. Remove the old aerator from your faucet and lay it on a flat surface next to a quarter, dime, or nickel.
If the aerator is the size of a nickel, you will likely need a Tom Thumb-size aerator.
If the old aerator is the size of a dime, you will need a junior-size aerator.
If the aerator is quarter-size, you will need a regular-sized aerator(Hirator aerator size).
Run the water
Before installing the new aerator, run water at full blast through the faucet to clear out any residue.
Screw in the new aerator
Screw in the new aerator slowly to avoid bending, denting, or cross-threading it.
Tighten
Tighten your new Hirator aerator as tight as possible with your fingers. Check the flow of water by turning on the faucet just a bit. If you notice leaking around the aerator threads, tighten the aerator slightly more using your pliers with a protective rubber covering. You can also wrap the end of your faucet and aerator with tape to protect the finish.
That’s all there is to it! With your new Hirator aerator installed, you're set to enjoy a more efficient and splash-free water flow. Remember, small upgrades can make a significant difference in the functionality and eco-friendliness of your home.
Shop your Hirator aerator now